iDuino Parts

You'll need all of the following parts. If you've purchased a kit, please verify its contents against this list. If you're sourcing your own components, this list includes supplier information.

This is the version 3 parts list. (The v2 parts list is here)

	Description	Qty	Supplier
	The iDuino PCB. This is the backbone of your iDuino; the FT232 chip is pre-soldered for your convenience. The USB connector may be pre-soldered as well.	1	Fundamental Logic
	AtMega168 µC. If you purchased a kit, the IC is pre-programmed with an Arduino bootloader.	1	Mouser 556-ATMEGA168-20PU
	28-pin socket.	1	Futurlec ICS28N
	10KΩ Resistor.	1	Various
	1KΩ Resistor.	4	Various
	0.1µF ceramic capacitor.	4	Futurlec C100UMC
	Electrolytic Capacitor. Various values depending on ESR. Must be 6mm diameter or smaller.	1	Various
	Pin Header. 0.100 spaced pin header 40 pins long. This will be cut down into shorter pieces as needed.	1	Various
	LEDs. 3mm LEDs. The kit contains two different colors.	2	Various
	6mm Tactile Switch.	1	Futurlec TACT001
	16MHz Ceramic Resonator. This is a 3-pin resonator with integrated capacitors.	1	Mouser 815-AWCR-16.00MD
	Right Angle USB B Connector. Your USB connector may be pre-soldered to the iDuino PCB.	1	Mouser 737-USB-B-S-RA