|
iDuino Parts
You'll need all of the following parts. If you've purchased a kit, please verify its contents against this list. If you're sourcing your own components, this list includes supplier information.
|
Description |
Qty |
Supplier |
 |
The iDuino PCB. This is the backbone of your iDuino; the FT232 chip is pre-soldered for your convenience. The USB connector may be pre-soldered as well. |
1 |
Fundamental Logic
|
 |
AtMega168 µC. If you purchased a kit, the IC is pre-programmed with an Arduino bootloader. |
1 |
Mouser 556-ATMEGA168-20PU
|
28-pin socket. If you purchased a kit, the socket has no middle member. |
1 |
Futurlec ICS28N
|
 |
10KΩ Resistor. |
1 |
Various |
 |
1KΩ Resistor. |
4 |
Various |
 |
0.1µF ceramic capacitor. |
5 |
Futurlec C100UMC
|
 |
Electrolytic Capacitor. Various values depending on ESR. Must be 6mm diameter or smaller. |
1 |
Various |
 |
Pin Headers. 0.100 spaced pin headers in 4,6,8, and 10 pin. Many people cut these down from longer strips. |
1 each (4 total) |
Various |
 |
2x3 pin Header. |
1 |
Various |
 |
LEDs. 3mm to 5mm LED. The kit contains two different colors. |
2 |
Various |
 |
6mm Tactile Switch. |
1 |
Futurlec TACT001
|
 |
16MHz Ceramic Resonator. This is a 3-pin resonator with integrated capacitors. |
1 |
Mouser 815-AWCR-16.00MD
|
 |
Right Angle USB B Connector. Your USB connector may be pre-soldered to the iDuino PCB. |
1 |
Mouser 737-USB-B-S-RA
|
|