Build A StickDuino

Intended Audience

The StickDuino is almost completely surface mount, with two SMT ICs and many SMT passive components; assembling a StickDuino is not intended for individuals not experienced with SMT soldering. This said, where possible large pads have been used, all components are 0603 or larger, and parts are loosely spaced.

SMT Soldering

Please see the new SMT Tutorials page.

Required Parts

Part	Quantity	Supplier/SPN
StickDuino PCB	1	Fundamental Logic
FT232RL	1	Mouser: 895-FT232RL
ATmega168-20AU	1	Mouser: 556-ATMEGA168-20AU
16MHz Crystal	1	Mouser: 815-ABL-16-B2
15uF 10v Tantalum Cap	1	Mouser: 74-293D156X9010A2TE3
SOD-123 Diode	1	Mouser: 833-MBR0540-TP
0.1uF 0603 MLCC	6	Mouser: 80-C0603C104M4R7545
18pF Ceramic Chip Cap	2	Mouser: 80-C0603C180J5G
1KΩ 0603 Resistor	3	Generic
10KΩ 0603 Resistor	1	Generic
0Ω 0603 Jumper	1	Mouser: 652-CR0603-J/-000ELF
1206 SMT LED	1	Mouser: 859-LTST-C230YKT

Assembly Diagram

Follow the pdf assembly diagram. stickduino-layout-w-label.pdf