Required Parts for a USB7

You'll need all of the following parts. If you've purchased a kit, please verify its contents against this list. If you're sourcing your own compoents, this list includes supplier information.

This is the version 1 and 2 parts list.

	Description	Qty	Supplier
	The USB7 PCB. This is the backbone of your USB7. There are two different USB7 PCBs, one with mounting holes and one without. You will need one or the other.	1	Fundamental Logic
	An Atmega48. The Atmega48 is the brains of your kit. The Atmega48 sold in the kit is pre-programmed with the latest firmware.	1	Mouser 556-ATMEGA48-20PU
	28 pin 0.300 DIP socket.		Futurlec ICS28N
	0.56" Dual 7 Segment LED Display. The kit includes your choice of several colours; even more colours are available directly though.	3	Mouser 630-HDSP-521G
	2N3906 PNP Transistor These transistors are used to rapidly illuminate each digit in sequence.	6	Fundamental Logic
	Diodes Generic silicon diodes. These are 1N4004s but any diode with a forward voltage drop around 0.7V will work fine.	2	Mouser 863-1N4004G
	Right Angle USB B Connector.	1	Mouser 737-USB-B-S-RA
	2x3 pin Header.	1	Various
	1.5KΩ Resistor.	1	Various
	1KΩ Resistor.	6	Various
	10KΩ Resistor.	1	Various
	68Ω Resistor.	2	Various
	82Ω Resistor.	8	Various
	12MHz Ceramic Resonator. This is a 3-pin resonator with integrated capacitors.	1	Mouser 815-AWCR-12.00MD